地热地板安装前需要进行的测量与检测
Measurement and testing of geothermal floor before installation

1、测量工程师上门进行测量，使用安装测量工具箱里面的红外线测距仪测量安装地板的面积、地板辅料的用量，避免因测量数据不准确而引起的二次运货。
1, the measurement engineer's door-to-door measurement, using the infrared range finder inside the installation measurement toolbox to measure the floor area and the amount of the floor auxiliary materials, to avoid the two shipment caused by the inaccurate measurement data.
2、对地面进行检测，先检测含水率，可以使用安装测量工具箱里面的含水率测量仪，将设备调至第二档(水泥、混泥土)，测试地表及墙脚的含水率，铺设地热地板要求含水率＜10%。 如果地面含水率过高，地板就容易吸水膨胀，造成地板起拱、起鼓、响声等问题，因此若地面含水率超过标准值，要进行除湿。
2. Test the ground, test the water content first, use the water content meter in the installation measurement toolbox, adjust the equipment to the second gear (cement, concrete), test the water content of the surface and wall, and the ground heat floor requires water content less than 10%. If the ground water content is too high, the floor will be easily swellable, causing the floor to arch, drum, sound and other problems, so if the ground water content exceeds the standard value, dehumidification should be carried out.
3、使用安装测量工具箱里面的红外线测温仪查看地暖供暖系统是否正常，打开供暖系统，检测地表温度变化，一切正常后方可进入下一步。同时测地面平整度，用2M靠尺平放在检查地面，用3mm厚的塞尺检查靠尺与地面的空隙，未通过则合格，通过则不合格。如果地面不平，则需要用铲刀凿平、情况严重的要重新找平或做自流平处理。
3, using the infrared thermometer inside the installation measurement toolbox to check whether the heating system is normal, open the heating system, detect the change of surface temperature, all the normal rear can enter the next step. At the same time, the ground flatness is measured, and the ground is placed on the scale by 2M, and the gap between the ruler and the ground is checked with a thick 3mm gauge. The pass is not passed, and the pass is unqualified. If the ground is uneven, it needs to be leveled with a shovel. If the situation is serious, it should be leveled or self leveled.